SINBO SSI 2858 - Manual (Page 12)

- 11 -
FILLING WITH WATER
The plug and cord should not be allowed to touch the sole plate. Let the iron cool down
completely before taking it away. Roll the power cord around the
1. Iron for storage.
2. Disconnect the iron form the wall outlet while filling with water or when emptying
the water after use.
3. The iron is for household use only.
SAVE THE INSTRUCTION MANUAL FOR FUTURE REFERRNCE
Notes:
• Some parts of the iron have been slightly greased and as a result, the iron may smoke
slightly when switched on for the first time. It will not happen again after a tow uses.
• Before using for the first time remove any protective films or stickers from the sole
plate and the cabinet. Clean the sole place with a soft cloth.
• When using the iron for the first time, test it on an old piece of fabric to ensure that
the sole plate and water tank are completely clean.
CHOICE OF WATER
• This iron can be used with normal tap water.
• If the water in your area is particularly hard, it is advisable to use distilled or deminer
alized water
• Do not use chemically descaled water or any other liquids for refilling.
HOW TO FILL IN WATER
• Set the Steam Control knob "0"and the Temperature Control Dali to OFF.
• Unplug the iron from the wall outlet, and wait for the iron to cool down.
• Pour water into the water inlet (5).
-Fill up to the maximum level "MAX" of the water tank.
SETTING THE TEMPERATURE
• Insert the plug in the wall socket and stand the iron upright.
• Turn the temperature control knob (1) to the desired temperature setting.
• The desired temperature has been reached when the pilot light has turned off. The
pilot light will turn on and off form time to time, indicating that the selected temperature
is being maintained.