MSD 6201 Digital 6A Ignition Control - Manual (Page 14)

14 INSTALLATION INSTRUCTIONS
M S D
• W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4
GM IGNITIONS Wiring an HEI 5 or 7-pin Module (Amplifier Trigger).
MAGNETIC PICKUP
(NOT USED)
GREEN (-) VIOLET (+)
*WHITE - CONNECTS TO BROWN AND TACH
*RED - CONNECTS TO 12 VOLTS AND PINK
BLACK
BROWN
HEAVY PINK
OR RED FROM
VEHICLE WIRE
HARNESS
DISTRIBUTOR
CONNECTOR
PINK
TO TACH
RED*
RED JUMPER
WHITE*
WHITE JUMPER
FACTORY
HARNESS
GRAY
TACH OUTPUT
DIGITAL 6AL
REV
LIMITER
*ORANGE - CONNECTS TO B+
*BLACK - CONNECTS TO C-
TO ENGINE
GROUND
ORANGE
ORANGE*
*
BLACK*
BLACK*
B+ GN
D C-
NOTE: Some 5-pin models may
experience a hesitation or stall
on deceleration. If this occurs,
contact MSD Tech Line for the
required bolt-in diode to correct
the problem. MSD Tech Line
(915) 855-7123.
GM IGNITIONS Wiring an HEI 4-pin Module (Magnetic Pickup Trigger).
PN 8860
HARNESS
WHITE
JUMPER
KEY
CONNECTOR
HEAV Y RED
OR PINK WIRE
FROM CAR
WIRING HARNESS
*ORANGE - CONNECTS TO B+
*BLACK - CONNECTS TO C-
CONDENSER
GM-CABLE
HARNESS GM MODULE
GROMMET
WIRE CLAMPS
REMOVE MODULE INSTALL HARNESS
MAGNETIC
PICKUP
CONNECTOR
TO ENGINE
GROUND
ORANGE
ORANGE*
*
BLACK*
BLACK*
PN 8861
HARNESS
B+
GN
D C-
GREEN (-)
VIOLET (+)
WHITE
(NOT USED)
COVER WITH TAPE
GRAY
TACH OUTPUT
RED
WHITE
DIGITAL 6AL
REV
LIMITER
NOTE: The GM Ignition Module and
condenser are removed and
replaced with the supplied
PN 8861 Harness.