MSD 8207 Blaster SS Coil Installation - Manual

IMPORTANT: Read instructions before attempting the installation.
Parts Included:
1 - Blaster SS Coil, PN 8207
3 - Vibration Mounts and Hardware
2 - Male Faston Connectors
WARNING: During installation, disconnect the battery cables. When disconnecting the battery,
always remove the Negative cable first and install it last.
Note: If installing the Blaster SS Coil to a points distributor or a non-current limiting ignition system without
an MSD Ignition, a 0.8 ohm ballast resistor is required (MSD PN 8214). The resistor should wire in
series along with any factory resistors on the
positive coil wire.
1. Find a suitable mounting location for the coil.
It can be mounted in any position as long as it
is away from direct engine heat sources.
2. Use the coil as a template and mark the
mounting holes using a punch.
3. Using a 3/16” drill bit, drill the three holes to
mount the coil.
4. Install the vibration mounts and mount the coil.
5. Install the Faston connectors to the coil
terminals. Connect the coil wires from the MSD
or stock ignition and the secondary coil wire.
MSD 6 or 7 Series Ignition Control
The Orange wire connects to the coil positive
terminal and the Black connects to the coil negative
terminal. These are the only two wires that connect
to the coil terminals.
MSD 5 or Blaster Ignition
The Red wire connects to coil positive and the
Orange connects to coil negative.
1 - 90° MSD Spark Plug Boot
1 - 90° Dual Crimp Terminal
WARNING: The Blaster SS and MSD Ignition Controls produce very high voltages. Never short the battery
or coil terminals. Use caution during installation and while working near the ignition or coil.
Figure 1 Mounting Template.
MSD Blaster SS Coil
PN 8207
ONLINE PRODUCT REGISTRATION: Register your MSD product online and you’ll be entered
in our monthly 8.5mm Super Conductor Spark Plug Wire give-away! Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.
M S D
• W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4