Naxa NPB-237 - Manual (Page 8)

E-7
All). You may also tap SKIP FORWARD "" BUTTON to go directly to other tracks ahead during
program play but you cannot use SKIP BACKWARD "" BUTTON to go back to previous track(s).
7. To review/edit the programmed tracks during play, press the STOP BUTTON and then the PROGRAM
BUTTON, the LED DISPLAY will automatically show the programmed tracks one by one in their correct
sequence starting from the first. At the end of program review, “01” in the LED DISPLAY and
PROGRAM INDICATOR will both flash. If you do not want to change any track in the program, press
PLAY BUTTON.
8. To edit a programmed track, use the SKIP FORWARD "" or SKIP BACKWARD "" BUTTON to
select a new track and press PROGRAM BUTTON to confirm. To skip forward, press PROGRAM
BUTTON until you reach the program number whose track you want to change.
9. To cancel program play, press the STOP BUTTON twice while program playback is running or open the
CD DOOR in stop mode.
BASS BOOST OPERATION
1. To enhance the low frequency sound, press the DBBS BUTTON once (button in) to activate.
2. Press the DBBS Button again (button out) to turn the Bass Boost off.
Note:
Please refer to the ON/OFF graphic on the Front Panel for correct operation of the Bass Boost function.
AUX IN OPERATION
This CD features an aux line-in jack for connecting your iPod, MP3 player or other digital music player.
1. Connect the headphone jack of your external device to the AUX IN jack located on the left side of this CD
player (The connection cable is not included).
2. Turn on the CD player and it will enter the AUX function mode once an external device is plugged into the
AUX IN jack.
3. Start to play your iPod, MP3 player or other external audio device.
4. Slowly adjust both volume controls on your CD player and the external device.
5. Turn off your iPod, MP3 player and etc. when finish listening. Turn the CD player off and unplug the AUX IN
jack.
Remark: Once the AUX IN jack is plugged, the CD player will automatically enter the AUX mode no matter the
Function Selector is in CD or Radio mode. Remember to disconnect the cable from the CD player after use in
order to be able to listen to the radio or CD player again.
SPECIFICATIONS
Frequency Range: AM 530 - 1710 kHz
FM 88 - 108 MHz
Power Sources: 120V~ 60Hz 12W or
8 x DC1.5V ‘C’ (UM-2) Batteries (Not included)
CARE AND MAINTENANCE
1. Children should be supervised when using this appliance.
2. Never wrap the earphone lead around any animal or person. Special care should be taken with long
wires.
3. Clean your unit with a damp (never wet) cloth. Solvent or detergent should never be used.
4. Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
5. Keep your unit away from heating appliances and sources of electrical noise such as fluorescent lamps
or motors.
6. If drop-outs or interruptions occur in the music during CD play, or if the CD
fails to play at all, its bottom surface may require cleaning. Before playing,
wipe the disc from the center outwards with a good soft cleaning cloth.