Naxa ND-851 - Manual (Page 18)

-17-
SYSTEM SETUP
In Custom Setup Page:
Press the Direction buttons , to select
, Password, or Default as desired , Parental Ctrl Angle Mark
then press the Direction button to enter.
1 Ctrl . If Parental is selected, press the direction button ( ) to enter.
The Password menu will appear on
(Default password is 5050). Press the Direction button , to set the rate level as below as
desired then press the ENTER button to confirm. Press the SETUP button to save the settings and exit. . the screen. Enter the four digit password by number buttons (0-9)
4. If Default is selected, press the Direction button to highlight reset. Press the Enter button to reset all
settings to default setting. Press the SET UP button to exit.
3. If Angle Mark is selected, press the Direction button to enter. Press the Direction buttons , to select ON
(When
multi-angle will not appear on the screen) as desired then press Enter button to confirm your selection . Press
the SET UP button to save the setting and exit. (Angle marks are not available on all DVDs.)
the multi-angles available on the disc, icon of multi-angle will appear on the screen) or OFF (Icon of
Rate levels:
1:KID SAF, Kidsafe
2 :G , All ages
3 :PG, Parental Guidance
4:PG-13, Parental Guidance less than 13 years old
5:PGR, Under 17 years old, Parental Guidance suggested
6:R, Under 17 years old, Parental Guidance strongly
7:NC+17 years old and above
8:ADULT, Adult only
2. If Password is selected, changed the password as follows:
A. Press the direction button to enter. The column will highlighted.
B. Enter the 4 digit current password by press the numeric buttons.
C. Enter the 4 digit new password by press the numeric buttons.
D. Enter the new password again.
E. Press the SETUP button to save the settings and exit.
Exit Setup Mode page:
Press the ENTER button to exit.