Naxa NCA-604 - Manual (Page 3)

INSTALLATION STEPS
1. Remove 2 screws for protecting deck;
1) Remove chassis from the Slide Bracket Housing as follows:
2) Remove 2 screws protecting the deck as
right;
2. Connecting all wires
1) Slide Bracket Housing;
2) Remove the control panel from the chassis as follows:
A. Press REL button to detach the control panel .
B. Hold the right end of the control panel to pull rightward
illustrated on the
Re-insert the chassis into the
a little and then remove it
REL button
PLASTIC TRIM OUT
KEY PLATE
KEY PLATE
If you want to remove the chassis from the Slide Bracket Housing , first remove the
Plastic trim from both sides, then insert 2 Key Plates into the left and the right side of
the chassis as illustrated.
-2-