ECTACO Partner 500 Al - Manual (Page 5)

ECTACO ® /OXFORD ® AnyLanguage™ 500AL User Manual
5
• Make sure to place the batteries according to the polarity marks (+ -) inside the
compartment.
ECTACO ® /OXFORD ® AnyLanguage™ 500AL is equipped with a mini-USB port for
external power supply via the shielded cable.
Use of an inappropriate external power supply may cause failure of the device and
may void the warranty. Always use the original accessories manufactured by
ECTACO, Inc.
REPROGRAMMING TO OTHER LANGUAGE PAIRS
ECTACO ® /OXFORD ® AnyLanguage™ 500AL can be reprogrammed to other
language pairs. To reprogram the device, perform the following steps:
1. If you already have the firmware package, copy it to an SD card of up to 2GB
capacity. Make sure the file system on the card is FAT. You can use the SD card
included in the standard package. More languages available for free download at
www.ectaco.com/ML500
2. Slide the card into the SD slot located on the right-hand edge of the device – the
label of the card face up, contacts face down. Push the card gently until it clicks into
place. To eject the card, just push it in slightly.
3. Turn the device on.
4. While holding down the ON/OFF button, press and release the Reset button. The
device screen will turn off. Keep the ON/OFF button pressed until the device screen
turns on.
You can also use the Replace Language Pack option in the Setup section.
5. Press ENTER and then follow the instructions on the screen.
6. Press the Reset button. Alternatively, press ESC.