Shogun Motorsports Honda CBR600RR (13-14) NO CUT Frame Slider - Manual (Page 3)

NOTE: There are tabs that help align the lowers with the mid-section. DO NOT force the lowers
to come off this can cause the tabs to break off.
2.
Remove left engine stud. There is a spacer that is located between the frame and the engine.
Your left side offset will mount in this location.
3.
Mount the left side offset using the stock OEM 12mm Hex Flange bolt.
Make sure that the wire
loom is routed properly and not being pinched by the offset in anyway. Line up the edge of the
offset (wile mounted) with the edge of the frame and torque down to OEM torque specs.