Shogun Motorsports Yamaha R1 (09-12) Frame Slider User Manual
Page 4
9.
For this application we used a Dremel tool with a sanding roll to open up the hole little by little.
MAKE SURE YOU WEAR PROTECTIVE GOGGLES AND GLOVES
As you cut and open the hole to your scribe
marks keep checking that the hole is lining up with your puck dimensions or the spot tool. If for some
reason you cut too big and you want to close the gap around the puck we use windscreen trim or
window seal with 3m adhesive. Trim the seal to fit the hole and get the seam to meet under the puck so
it is less visible.
10.
Mount left side panel.
11.
Mount left side puck with 99-HB-SH121250120 Socket Cap 12 X 1.25 X 120 Main Engine Stud
and torque down.
12.
Repeat all installation steps for the right side.
READ CAREFULLY
Shogun cannot guarantee that they will protect your motorcycle from any extent of damage.
Shogun frame sliders are really meant to help possibly save the frame from damage in the event of a
crash. Because Shogun frame slider products have been very successful in saving cases, bodywork,
levers and so on in the past, customers just assume sometimes you can put the product on and no
damage will happen. The fact is, some crashes result in little or no damage to the motorcycle and some
bikes are destroyed. It’s kind of like a bumper on a car sometimes it works sometimes it doesn’t, it really
depends on all the different forces applied during the incident. We’ve seen bikes crash at 100 mph with
little damage and some at 15 mph with major damage.