Shogun Motorsports Kawasaki ZX6R (09-12) Frame Slider - Manual

Kawasaki ZX6R (09-12) Frame Slider Installation
Instructions
Part Numbers: 750-4429, 755-4429, 750-4420,
850-4420
MADE IN THE USA!
Carefully read instructions in their entirety before the install
Professional installation is recommended. Always use proper safety measures during the install of this
product. Do not try to install this product without proper tools, recently calibrated torque wrench,
correct torque specifications from
factory service manual , safety goggles and gloves. The motorcycle
must be in a fixed secure position before the install process begins. DO NOT remove both engine studs
at the same time.
Shogun is not responsible for any part of your motorcycle for any reason. If you have
any questions please call us directly for assistance.
Replacement Parts List: Left Side Components (as if you were sitting on the bike)
QTY
Price each Part Numbers Descriptions
1
$20.00 99-FS-750-4429-L Black Left Side Puck
1 $20.00 99-FS-750-4420-L White Left Side Puck
1 $30.00 99-FS-850-4420-L Chrome Left Side Puck
1 $30.00 99-OF-750-4420-L Left Side Offset Black Anodized
1 $2.00 99-HB-SH10150045 Socket Cap 10 X 1.5 X 45 (Holds puck to offset)
1 $3.50 99-HB-SH10125060 Socket Cap 10 X 1.25 X 60 Main Engine Stud
Replacement Parts List: Right Side Components (as if you were sitting on the bike)
1
$20.00 99-FS-750-4429-R Black Right Side Puck
1 $20.00 99-FS-750-4420-R White Right Side Puck
1 $30.00 99-FS-850-4420-R Chrome Right Side Puck
1 $30.00 99-OF-750-4420-R Right Side Offset Black Anodized
1 $2.00 99-HB-SH10150045 Socket Cap 10 X 1.5 X 45 (Holds puck to offset)
1 $3.50 99-HB-SH10125070 Socket Cap 10 X 1.25 X 70 Main Engine Stud
Frame Sliders: Left frame slider longer than right.
Offsets: If you were to hang both offsets from one bolt the left side offset hangs lower than right.
Installation Steps:
1. Remove mid and lower body panels Left and Right. There is a small plastic cover that is mounted
over the main engine stud location on the left side. This cover requires a small notch to be cut
out of the cover to clear the small end of the left side offset. Remove stock stud and mount the
left side offset (with 10 X 1.25 X 60). Using a pencil, trace out the notch that you need to remove
to clear the small end of the offset. We used a Dremel tool with a sanding roll and cleaned it up
with an exacto knife. We removed a small amount of material at a time checking for clearance
each time. The notch will not be visible after the body has been mounted. See photos below: