Shogun Motorsports Suzuki GSXR1000 (2009) Frame Slider User Manual
Page 3
7.
A compass was then used to draw our diameter of desired shaped hole. A flexible hole template
can also be used for the same purpose.
8.
Use a step drill to open the hole enough to accept your dremel tool.
9.
For this application we used a dremel tool with a sanding roll to open up the hole little by little.
MAKE SURE YOU WEAR PROTECTIVE GOGGLES AND GLOVES
As you cut and open the hole to
your scribe marks keep checking that the hole is lining up with your puck dimensions or the spot
tool. If for some reason you cut too big and you want to close the gap around the puck we use
windscreen trim or window seal with 3m adhesive. Trim the seal to fit the hole and get the seam
to meet under the puck so it is less visible.
10.
Mount right & left side puck with (99-HB-SH10125090) Socket Cap 10 X 1.25 X 90 Main Engine
Stud and torque down to OEM specs.