Spicer Carrier-To-Housing Joint Leak User Manual
Page 6
8. Install new fasteners supplied in kit and run them down with an impact gun in a crisscross pattern.
9. Most ½” drive impact guns will put out a maximum torque of 250-300 ft. lbs. Check at least one capscrew to verify that
your impact gun is putting out a minimum of 250 ft. lbs.
10. Clean axle shaft flanges and wheel hub surfaces and install new axle shaft gasket.
11. Reinstall the axle shaft, washers and nuts, torque to spec.
12.
Reconnect IAD shift cylinder airline.
13.
Reinstall the driveline.
14. Remove fill plug from housing cover and refill the housing using the same lubricant that was removed. If needed, add
lube and fill until level with the bottom of the fill hole.
For spec’ing or service assistance, call 1-800
-621-8084 24 hours a day, 7 days a week.
Or visit our web site at:
http://www.
spicerparts.com
Dana Corporation
SHAIS135B
Copyright Dana Corporation, 2008
Heavy Vehicle Technologies and Systems Service
January 2008
All Rights Reserved.
P.O. Box
321
Printed in U.S.A.
www.dana.com/
Toledo, Ohio 43697-0321
Model Series
Dana Part-No. Fastener Location
Class
Size
lbs-ft
N.m
D/R344, 404
127567
Carrier - to - Housing Nut
12
M16x1.5
250-300
312-366
130158
Carrier - to - Housing Capscrew
12.9
M16x2
250-300
312-366
Torque Specification Chart - (Carrier - to - Housing)