Spicer Drive Axles Service Manual - Manual (Page 9)

7
DIFFERENTIAL DISASSEMBLY
1. Match mark differential case halves with punch or
chisel for correct alignment during reassembly.
See
Figure 2.
FFFFFigur igur igur igur igure 2 e 2 e 2 e 2 e 2
6. If differential side bearings are to be replaced,
remove old bearings using suitable puller.
See
Figure 3.
NOTE: Inspect all parts, including the machined
surfaces of the case itself.
2. Remove differential case nuts and lift off the
differential case half.
3. Remove thrust washer and differential side gear.
4. Lift out cross shaft, pinion mates and thrust washer.
5. Remove second differential side gear and thrust
washers.
Differential Case Cap Half
Differential Bearing Cap
Differential Bearing Cap Bolt
(115-135 Lb-Ft)
(155-183 N-m)
Differential Case Flange Half
Differential
Bearing Cup
Differential Pinion Mate
Differential Pinion Mate Thrust Washer
Differential Gear Thrust Washer
Differential Side Gear
Differential Case Bolt
Ring Gear
Oil Scoop
Hex Bolt
(7-9 Lb-Ft)
(9-12 N-m)
Cotter Pin
Adjusting Ring
Lock
Differential Bearing
Cap Washer
Adjusting
Ring
Differential
Bearing Cone
Differential Case Nut
(75-90 Lb-Ft)
(100-120 N-m)
Differential Cross Shaft
Ring Gear Rivet
Washer
Ring Gear Bolt Kit
(300-320 Lb-Ft)
(406-434 N-m)
(Optional)
FFFFFigur igur igur igur igure 3 e 3 e 3 e 3 e 3