Spicer DS462 User Manual
Page 5
13. Third Pass Cover Weld – The third pass should cover the lower half of the second pass and stop at the
housing covers edge. Again, reverse the direction of the weld. Remember, do not start or stop at the 12:00
position.
Third Weld Pass
Housing
Cover
Third Pass Cover
14.
Clean and paint the repaired area.
15. Reinstall the torque rod.
16. Reinstall inter axle driveline.
17. Reinstall tires and rims.
18. Reconnect grounds and oil temperature wire.
If you have any questions about this procedure call the Roadranger Call Center at 1-800-826-4357.
For spec’ing or service assistance, call 1-800-
621-8084 24 hours a day, 7 days a week.
Or visit our web site at:
www.
VSLFHUSDUWV.com
Dana Corporation
Copyright Dana Corporation, 2002
Commercial Vehicle Axle Division
June
2002 All
Rights
Reserved. P.O.
Box
321
Printed in U.S.A.
Toledo, Ohio 43697-0321
5