Spicer 119353 - Manual

1
Spicer ®
Drive Axles
P/N: SHAIS190B
INFORMATION SHEET – 119353 NUT TORQUE
Affected Models: All Dana models that use the 119353 Locknut
Below are the general specifications for 119353 locknut. This is a “torque prevailing” locknut. The
nut is to be used on drive pinions that have two .250” [6.35 mm] diameter holes drilled thru the
threads.
Torque nut to the amount listed below. Align slot in nut to the next pin hole by tightening nut. Insert
pin into slot flush with flats of nut.
Part-No: 119353
Thread Size: 1.750” x 12
Socket Size: 2 5/8”
Torque: 900 - 980 lbs. ft (1220 - 1328 N
.
m)
Copyright Dana Limited, 2013 Dana Aftermarket Group
SHAIS190B FEB 2013 All Rights Reserved. P.O. Box 321
Printed in U.S.A. Dana Limited Toledo, OH 43697-0321