Spicer Jeep Grand Cherokee WJ 44-4 SERVICE MANUAL - Manual (Page 25)

25
X5001-CVSP
4. Press the ring gear onto the case (Figure 80). 9. Lubricate the outer and inner lip seals on the
plenum using the same lube as required for
filling the unit (Figure 82).
8. Turn the case over to install the flange side
bearing.
NOTE: Be sure to use a plug or other type of
support on the button side to prevent the case
from being damaged when the second bearing is
installed.
10. Install the plenum by rotating it around the
hub (Figure 83). Press downward to seal the
plenum against the sealing surfaces on the
case and to prevent damaging the seal.
5. Start all of the ring gear bolts, and then press
the ring gear onto the case.
Do not use the ring gear bolts
to pull the ring gear onto the case. This will
stretch the bolt threads and the bolts may not
hold their required torque.
6. Tighten the bolts, and torque them to 70 to
90 ft. lbs.
7. Drive the bearing onto the button side of the
hub using a Miller tool C-4340 (Figure 81).
Figure 80
Figure 81
Figure 82
Figure 83
WARNING