Spicer S110 - Manual (Page 11)

9
Gear & Pinion Kits
Ring Gear & Pinion Identification
Dana has highly developed primary axle gearing which is only used in matched sets. These sets are identified by the mating parts listed below. Within
any Dana production drive axle or genuine Spicer® Gear & Pinion service kits, these mated part numbers will appear. Because they are developed as a
set with precision machining, never mix gears and pinions from different mated sets within an axle. Shortened gearing life, noise and failure may occur.
Always use genuine Spicer® products.
• Ring Gear and Drive Pinion are matched parts and must be replaced in sets.
• Identification of mated parts are shown on the drawing below.
• The Service Gear & Pinion kits below include ABS option cutout on ring gear. Tone rings are sold seperately.
Single Reduction
Ring Gear
Pinion
Matched Gear Set Number Part Number
Ring Gear Teeth
Manufacturing Numbers
L7038
88678
39-6 EA-93
JF-1
9
L7038
Side
Self Locking Nut
Front
Pinion Teeth
Manufacturing Numbers
Part Number
6-39 JD77
93
85405
SPICER
Ring Gear Teeth
Pinion Teeth
Indicates Genuine
Spicer Parts Gear & Pinion Kits - S110 Models
34 Inv. Spline
12.25” (311 mm) Hypoid Gearing
Pinion Nut Part No. 130542
The Kits below include: Two brg cone part# HB105, two cup part# HA102 and qty (12) 130595 cap screw
Mated Gear/Pinion Set Mated Gear/Pinion Set Mated Gear/Pinion Set
Spicer Generation 1 Generation 2 Generation 3 Tooth
Ratio Kit P/N Gear (NSS) Pinion (NSS) Gear (NSS) Pinion (NSS) Gear (NSS) Pinion (NSS) Combo Notes
3.73 511831 130519 130537 132953 132898 132953 139758 41/11
3.91 511832 130604 130535 132954 132899 132954 139759 43/11
4.10 511833 130519 130536 132955 132900 132955 139760 41/10
4.30 512277 130604 130534 132956 132901 132956 139761 43/10 Replaces 511834
4.56 511835 130513 130527 132957 132902 132957 139763 41/9
4.78 511836 130515 130530 132958 132903 132958 139764 43/9
4.88 511837 130517 130533 132959 132904 132959 139765 39/8
5.13 511838 130513 130526 132960 132905 132960 139766 41/8
5.38 512279 130515 130529 132961 132906 132961 139767 43/8 Replaces 511839
5.57 511840 130517 130532 132962 132907 132962 139768 39/7
5.86 511841 130513 130525 132963 132908 132963 139769 41/7
6.14 511842 130515 130528 132964 132909 132964 139770 43/7
6.50 511843 130517 130531 132965 132910 132965 139771 39/6
Note: Dana has produced various generations of gear sets as detailed above. In doing this unique individual part numbers were used to identify either the
supplying plant location or manufacturing differences. Dana Genuine Service kits are supplied with the most current design parts for service.