Spicer Driveline Components Catalog - Center Yokes, Tube Yokes and Ball, Stud Tube Yokes - Manual (Page 3)

Important: See Safety Information in General Information Section (J300P-GI) 3
J300P-5
Important: See Safety Information in General Information Section (J300P-GI)
HOW TO USE THIS CATALOG
Footnotes for parts and assemblies that are discontinued, will be discontinued upon depletion of
stock, or not sold separately, are indicated by a symbol next to the part number. Match the symbol
to the appropriate status at the bottom of the page. All other footnotes are located immediately
below the yoke dimensional data.
IMPORTANT NOTICE: The data listed herein is correct to the best of our knowledge and belief;
having been compiled from reliable and official sources of information. However, WE CANNOT
ASSUME ANY RESPONSIBILITY for possible error.
HOW TO IDENTIFY A BALL STUD TUBE YOKE USING THIS CATALOG
To identify any tube yoke, the following information is required:
1. Determine the Series
2. Determine the size and wall thickness of the tube it fits
3. Determine the dimension from center of joint to weld point
4. Determine the center of the joint to the end of the ball stud dimension
5. Determine the diameter of the ball stud
6. Determine the length of the ball stud
7. Determine the configuration and dimensions of the slinger or seal (if the part has a slinger or seal)
Example: To find a 1310 Series ball stud tube yoke with a 1.438 center to weld dimension, that fits a
2.000 OD tube with a .120 wall thickness and a .500 diameter ball stud, see the following example:
1. Find the 1310 Series heading
2. Find the 2.000 Tubing Diameter and .120 wall thickness (2.000 x .120W)
3. Find the 1.440 Center to Weld dimension
4. Find the 1.641 Center to End of Ball Stud dimension
5. Find the .594 Ball Stud Length
6. Refer to the slinger and seal illustrations on page 13 to determine which seal/slinger configuration
you have.
If you have a seal, order Spicer ball stud tube yoke assembly part number 2-28-2867X
If you have a slinger, order Spicer ball stud tube yoke assembly part number 2-28-2947X
Be sure to read any notes that are provided.
Series and all pertinent series dimensions appear as shown in the sample below:
1310 SERIES E-3.469 D-1.062 USE KIT 5-153X, 5-785X, 5-810X, 5-786X
1.250 X.120 W 1.016 1.500 1.641 .594 .500 231864 2-28-2997X
1.750 X.095 W 1.562 1.440 1.641 .594 .500 2-86-418 2-28-2827X
1.750 X.095 W 1.562 1.440 1.641 .594 .500 231864 2-28-2937X
2.000 X.120 W 1.766 1.440 1.641 .594 .500 2-86-418 2-28-2867X
2.000 X.120 W 1.766 1.440 1.641 .594 .500 231864 2-28-2947X
2.500 X.065 W 2.375 1.440 1.641 .594 .500 2-86-418 2-28-3087X
For Use With F K J Ball Stud Ball Stud
Tube Butt Centerline Centerline L H Slinger/Seal Tube Yoke
Diameter Diameter to Point to End of Length Diameter Assembly
& Wall Thickness of Weld Ball Stud Part Number
1
2
3 4 5 6