Spicer Shift Fork Spring Installation - Manual

Spicer ®
Drive Axles
P/N: SHAIS209A
Information Sheet: SHIFT FORK SPRING PIN INSTALLATION
Affected Models: Various Dana Diff Lock models
Dana diff lock design shift forks utilize a spring pin to hold the sliding clutch onto the shift fork. If removing or assembling
the spring pin, shift fork or sliding clutch follow the procedures below.
Note: In some Dana Shift Fork kits or sub-assemblies, the spring pin may have been “pre-installed” into the shift fork so the pin is not lost in
shipping. Be sure to follow and complete the “assembly” procedures when installing the sliding clutch onto the shift fork.
•
Disassembly: Use a pin punch to remove spring pin from the fork leg. Remove sliding clutch.
• Assembly: To assemble the individual parts (shift fork, spring pin & sliding clutch), insert the shift fork onto the sliding
clutch. Using a hammer, drive the spring pin thru shift fork pin hole opening until flush to the outer portion of the shift
fork surface. This will lock the sliding clutch in place.
For any other specifications or service assistance call 1-877-777-5360 or visit www.spicerparts.com.
Copyright Dana Limited, 2013 Dana Aftermarket Group
SHAIS209A JUNE 2013 All Rights Reserved. P.O. Box 321
Printed in U.S.A. Dana Limited Toledo, OH 43697-0321