Spicer 23080S User Manual
Page 3
3
INFORMATION BULLETIN ABIB-0107R2 - Component Upgrades in 23080S Single Drive Axle Models
The Dana illustrated parts book for these models is currently not updated so a comprehensive listing of general service
parts and kits are shown below.
Models: 21080S/D, 23080S/D, 26080S/D, 21090S/D, 23090S/D, 26090S/D
• Service Carriers – Refer to Dana publication AXIP-0070
• Axle Housings – Contact your OEM for specific part numbers
• Axle Shafts – Refer to Dana publication AXIP-0078
AXLE HOUSING HARDWARE KIT –
NEW!
514299
– Carrier-to-housing fastener parts kit – For all 23080/23090 models
BEARING KITS
511891
– For models After 12/1999
(see note 1 on page 2)
213744
– For models Before 12/1999
(see note 1 on page 2)
CARRIER/CAP KIT
213652
– For Standard models (casting#129158R)
210701
– For Diff-Lock models (casting#210697R) was P/N 129427
OILSEAL & SHIM KIT
119796
– Contains pinion seal, shims and rtv sealant
PINION LOCKNUT
128049
– M42-1.5 (use 55mm socket)
PINION OILSEAL
210724
– Microlip design
PINION OILSEAL INSTALLATION TOOL
210749
– Driver tool
RING GEAR NUT & BOLT KIT
121790
– 36 Inv spline side gears
SHIFT CYLINDER SERVICE KITS – FOR DIFF-LOCK EQUIPPED MODELS
507494
– For Diff-Lock models – includes Dana
COVER P/N 129005
(has ¼” threaded airline hole)
510161
– For Diff-Lock models – includes Dana
COVER P/N 129004
(has 12mm metric threaded airline hole)
130155
– Shift Cylinder Cover - (used by International Truck & Engine Company – has ¼” threaded airline hole)
SHIFT FORK ASSEMBLY
219456
– Used in Diff-Lock equipped models
WHEEL DIFF SIDE GEAR KIT
121785
– 36 Inv spline side gear (side gear is P/N: 118959)
WHEEL DIFF KIT – LESS THE SIDE GEARS
121786
– Includes side pinions, differential spider and thrust washers
WHEEL DIFFERENTIAL CASE KITS – STANDARD MODELS
121787
– 2.85-3.70 ratio (flange half case p/n: 210504-NSS)
121788
– 3.90-4.33 ratio (flange half case p/n: 210505-NSS)
121789
– 4.63-7.17 ratio (flange half case p/n: 210506-NSS)
WHEEL DIFFERENTIAL CASE KITS – DIFF LOCK MODELS
212007
– 2.85-3.70 ratio (flange half case p/n: 126858-NSS)
212008
– 3.90-4.33 ratio (flange half case p/n: 126859-NSS)
212009
– 4.63-7.17 ratio (flange half case p/n: 126860-NSS)