STM SatLink 4033 Transceiver - Manual (Page 2)

SatLink 4033
Ku-Band Transceiver
Specifications
Frequency: 14.0 - 14.5 GHz
P1dB Compression: 33 dBm
RF Interface
IF Interface
Local Oscillator
Frequency: 950 - 1450 MHz
Connector: F-type, 75 Ohms
DC Supply: 18-28 VDC
Power Consumption: < 20 Watt
Control Channel
Extended DiSEqC v. 4.2
22 kHz two-way signaling downstream channel
RF Interface
Frequency: 10.7 - 12.75 GHz
Noise Figure at OMT: 1.0 dB typical
Conversion Gain: 58 - 68 dB
IF Interface
Frequency: 950 - 2150 MHz
Connector: F-type, 75 Ohms
Output Level, P1dB: +5 dBm
DC Supply: 13 - 18 VDC
Current Drain: 120 mA Maximum
Band Selection (Lo/Hi): 22 kHz Tone (Off/On)
Physical/Environmental
Temperature: -35°C to +55°C (operating); -35°C to
+80°C (storage)
Humidity: 0 to 100 % condensing (operating); 0 to 100
% non-condensing (storage)
IP Grade: IP 64
Size: 21.1 x 14.1 x 4.4 cm
Weight: 1.2 kg
www.stmi.com
STM Group, Inc. | 2 Faraday | Irvine, CA 92618, USA | T +1 949 273 6800 | FAX +1 949 273 6020
STM Norway AS | Vollsveien 21 | 1366 Lysaker, Norway | T +47 6753 5337 | FAX +47 6753 5335
All specifications and features subject to change without notice. SatLink and the STM logo are a registered trademarks of STM Group, Inc.
The DVB logo is a registered trademark of the DVB Project (www.DVB.org). DiSEqC is a trademark of Eutelsat.
Document #105536 ; Revision J - 110830 © 2011
Local Oscillator
Frequency: 9.75 GHz (Lo band); 10.6 GHz (Hi band)
SSB Phase Noise: 10 kHz : -85 dBc/Hz; 100 kHz : -105
dBc/Hz; 1 MHz : -120 dBc/Hz
L.O. Stability: +/- 1 MHz
Gain & Spurious
Linear Gain: 57 dB typical
Gain Ripple - 500 MHz: 4 dB typical
Gain Ripple - 50 MHz: 1.5 dB typical
Temperature Stability: 3 dB
Spurious in Tx Band: -50 dBc
Transmitter Receiver
Frequency: 13.05 GHz, locked to ext. ref.
Reference Frequency: 10 MHz (fed via Tx connector)
Reference Level : -5 to +5 dBm
SSB Phase Noise: 1 kHz : -70 dBc/Hz; 10 kHz : -80 dBc/
Hz; 100 kHz : -93 dBc/Hz; 1 MHz : -117 dBc/Hz
Antenna Interface
Polarization: Linear / Linear, Cross-polar
Feed-horn Interface: C120
Tx/Rx Cross-polar Level: 35 dB / 35 dB
Compliance
Regulatory: CE (R&TTE), Anatel