Veris Industries TP SERIES Install - Manual

Z206424-0B PAGE 1 ©2012 Veris Industries USA 800.354.8556 or +1.503.598.4564 / [email protected] 10121
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
TM
ENVIRONMENTAL SENSORS INSTALLATION GUIDE
Flush Mounted Temperature Sensor SPECIFICATIONS
Wiring 22 AWG; 2-wire: RTD/Thermistor
Housing Brushed 430 Stainless Steel
Operating Temperature Range -10° to 50°C (14° to 122°F)
TP
NOTICE
• This product is not intended for life or safety applications.
• Do not install this product in hazardous or classified locations.
• Read and understand the instructions before installing
this product.
• Turn off all power supplying equipment before working on it.
• The installer is responsible for conformance to all applicable codes.
TP
PRODUCT IDENTIFICATION
INSTALLATION
1. Wire the TP as shown.
DIGITAL CONTROL
Thermistor/RTD Orange
Back of TP steel plate
2. Using the screws provided, mount the TP to a single-gang box on an interior wall
in the area to be monitored, in a location where air circulates freely. Locate the
unit away from air outlets, corners, exterior walls, windows, and doors. Make sure
the foam insulation is placed inside the steel plate, allowing access to the screw
holes.
Sensor Type Cal Certificate
0 = None
1 = 1 point Cal validation
2 = 2 point Cal validation B = 100R platinum, RTD
C = 1k platinum, RTD
D = 10k T2, Thermistor
E = 2.2k, Thermistor
F = 3k, Thermistor
G = 10k CPC, Thermistor
H = 10k T3, Thermistor
J = 10k Dale, Thermistor
K = 10k w/11k shunt, Thermistor
M = 20k NTC, Thermistor
N = 1800 ohm, Thermistor
R = 10k US, Thermistor
S = 10k 3A221, Thermistor
T = 100k, Thermistor
U = 20k “D”, Thermistor
W = 10k T2 high accuracy, Thermistor
Y = 10k T3 high accuracy, Thermistor
Z = 10k E1, Thermistor
PRODUCT OVERVIEW
TP flush mounted temperature sensors monitor the temperature of the air in a room.
They are ideal for spaces where moisture and vapor are concerns. The back of the TP
is insulated to reduce interior wall temperature influence. The TP is for indoor use
only, and it is warranted for a period of five years.
DIMENSIONS
4.5”
(115 mm)
2.8”
(72 mm)
1.4”
(36 mm)
3.3”
(84 mm)
2x Ø 0.175”
(5 mm)