Veris Industries E682x SERIES Install - Manual

Z206159-0A PAGE 1 ©2012 Veris Industries USA 800.354.8556 or +1.503.598.4564 / [email protected] 07123
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
TM
POWER MONITORING INSTALLATION GUIDE
Installer’s Specifications
Inputs:
Frequency Range 50/60 Hz
Leads 6’ (1.8 m)
Accuracy:
Accuracy ±0.5% from 5%-120% of rated current
Outputs:
Output at Rated Current 0.333 VAC
Mechanical:
Insulation 600 VAC
Environmental:
Operating Temperature Range -40° to 85°C (-40° to 185°F)
Storage Temperature Range -50° to 105°C (-58° to 221°F)
Humidity Range 0-95% noncondensing
Altitude of Operation 3 km max.
Installation Category Cat III, pollution degree 2
Agency Approvals UL61010-1, EN61010-1
0.333 VAC Solid-Core Current Transducers
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• Follow safe electrical work practices. See NFPA 70E in the USA, or applicable local codes.
• This equipment must only be installed and serviced by qualified electrical personnel.
• Read, understand and follow the instructions before installing this product.
• Turn off all power supplying equipment before working on or inside the equipment.
• Use a properly rated voltage sensing device to confirm power is off.
DO NOT DEPEND ON THIS PRODUCT FOR VOLTAGE INDICATION
Failure to follow these instructions will result in death or serious injury.
DANGER
NOTICE
• This product is not intended for life or safety applications.
• Do not install this product in hazardous or classified locations.
• The installer is responsible for conformance to all applicable codes.
• Mount this product inside a suitable fire and electrical enclosure.
Product IdentIfIcatIon
PART NUMBER DESCRIPTION
E682A051V3 Solid-Core Volt CT, 50A:0.333V, 0.417 in ID, 6 ft leads
E682A101V3 Solid-Core Volt CT, 100A:0.333V, 0.417 in ID, 6 ft leads
E682C201V3 Solid-Core Volt CT, 200A:0.333V, 1.0 in ID, 6 ft leads
E682D401V3 Solid-Core Volt CT, 400A:0.333V, 1.25 in ID, 6 ft leads
Other lead lengths are available. Consult a sales rep for more information.
InstallatIon
Installation must be performed by a qualified electrician.
Disconnect and lock out power to the primary circuit
before installing these current transducers (CTs).
1. Connect the transducer output leads to the meter or device inputs. The white wire
is the X1 lead. Note the labeling on the product indicating the source side, or the
base of the arrow.
2. Run the conductor to be monitored through the CT center and complete
connections.
3. Check wire terminations for tightness.
4. Reconnect power to the panel.
E682x SERIES
Documentation must be consulted where this symbol is used on the product.
This symbol indicates an electrical shock hazard exists.
Always use this product in the manner specified or the protection provided by the
product may be impaired. This product must be installed in an appropriate Fire and
Electrical enclosure per local regulations.
E682x SERIES