Veris Industries T SERIES Install - Manual

Installation Guide
Temperature
Z203672-0C Page 1 of 7 ©2013 Veris Industries USA 800.354.8556 or +1.503.598.4564 / [email protected] 09131
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
Other companies’ trademarks are hereby acknowledged to belong to their respective owners.
TM
NOTICE
• This product is not intended for life or safety applications.
• Do not install this product in hazardous or classified locations.
• Read and understand the instructions before installing
this product.
• Turn off all power supplying equipment before working on it.
• The installer is responsible for conformance to all applicable codes.
No responsibility is assumed by Veris Industries for any consequences arising out of the
use of this material.
Product Identification
Product Overview
T Series temperature sensors are available with linitemp output. T Series devices come with several mounting
options, including duct, wall, ceiling, outdoor, remote, and immersion. Where applicable, keep all vents clear of
dust and debris. All T series devices are warranted for a period of five years.
T Series
Temperature Sensors with Linitemp
TS
TRA
TD
TW
= 10mV/°C, Linitemp
Sensor Type
TC
Probe Length
B = 4" (102mm)
C = 6" (152mm)
D = 8" (203mm)
E = 12" (305mm)
F = 18" (457mm)
G = 24" (610mm)
Cal Certificate
Sensor Type
TS
= 10mV/°C, Linitemp
Cal Certificate
0 = None
1 = 1 point Cal validation
2 = 2 point Cal validation
0 = None
1 = 1 point Cal validation
2 = 2 point Cal validation
TRA
P
P
Sensor Type
TW
Local Display
L = LCD
X = No
Setpoint/Override Cal Certificate
= None 0 = None
1 = 1 point Cal validation
2 = 2 point Cal validation = 10mV/°C, Linitemp
P
Sensor Type
TO
= 10mV/°C, Linitemp
Cal Certificate
0 = None
1 = 1 point Cal validation
2 = 2 point Cal validation
Output
= Resistive Output
RØ P