Veris Industries MSBPM1x Install - Manual (Page 2)

ZL0031-0B PAGE 2 ©2012 Veris Industries USA 800.354.8556 or +1.503.598.4564 / [email protected] 02121
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
TM
MSBPM1x INSTALLATION GUIDE
INSTALLATION AND WIRING
1. Turn off power at the circuit breaker. Use a properly rated voltage sensing device to
confirm power is off.
2. Remove existing wall switch, if applicable.
3. Wire the sensor according to the applicable wiring diagram below.
Single Level
LOAD
Neutral (WHT)
Ground (GRN)
Hot (BLK)
(RED)
Bi-Level
(RED)
LOAD
LOAD
Neutral (WHT)
Ground (GRN)
Hot (BLK)
4. Mount sensor in electrical box and secure with two captive screws. Ensure that
sensor has an unobstructed view of the entire coverage area.
5. Attach wall plate (included) with two screws provided.
6. Turn on power at the circuit breaker.
7. Press the On/Off button to turn on the switch. The lights will not turn on
automatically. When motion is detected, the red LED at the top of the sensor will
flash on for approximately 0.5 seconds, and the lights will remain on.
Note: when first installed, the sensor may have to warm up for a few minutes
before it is fully operational.
8. Vacate the room until the lights turn off.
9. Re-enter the room. Lights should turn on immediately. If not, check the wiring and
ground connection and toggle the Auto/Off button.
Adjustment:
1. Remove the adjustment access cover (located between the sensor lens and Auto/
Off button) by gently prying it off with a small, flathead screwdriver.
Adjustment
Dial
Bypass button
(In = Always ON,
Out = Normal
Operation)
2. Time Delay: The Time Delay determines how long the lights will stay on when
motion is no longer detected. Turn the adjustment dial to the desired setting:
from 15 sec. (fully counter-clockwise) to 30 min. (fully clockwise).
3. Bypass: A latching bypass button is provided on the wall plate. In = Always On,
Out = Normal Operation.
4. Masking (optional): To reduce unwanted motion sensing, such as people moving
in adjacent areas, partially mask the sensor lens with opaque adhesive tape (not
included).
5. Replace the adjustment access cover by gently snapping it in place.