VTech IS7121_-2-22 Abridged manual - Manual (Page 11)


Call intercept
If you want to talk to the person whose message is being recorded, press or .
Add and register a handset
The cordless handset provided with your phone system is already registered. Each
handset is assigned a number that displays on the handset. Additional handsets
registered to the telephone system are assigned numbers in the sequential order.
This telephone system accommodates up to  handsets, including a maximum of
two doorbells.
You can add new handsets (
IS7101, purchased separately) to your telephone
system. Each handset must be registered with the telephone base before use.
When first purchased and properly charged, each expansion handset displays
Put handset on BASE to register. The new handset should be charged without
interruption for at least 30 minutes before registering it to the telephone base.
To register a handset:
Make sure the handset is out of the telephone base or handset charger and
shows Put handset on BASE to register. Place the handset you wish to
register in the telephone base.
The handset displays
Registering handset... then displays HANDSET X
Registered, and you hear a confirmation tone from the handset when
registration completes. It takes about 0 seconds to complete the
registration process.
Add and register a doorbell
The doorbell provided is already paired to the telephone base. You can add or
replace doorbells ( IS741, purchased separately) to your telephone system. This
telephone system accommodates up to two doorbells.
Each new doorbell must be paired to the telephone base before use.
Make sure you plug in AC power before pairing it to the telephone base.
Press and hold /FIND HANDSET on the telephone base for about four seconds
until the IN USE light turns on.
Press and hold / DOORBELL for about 0 seconds until the doorbell light
flashes slowly. The doorbell light turns on and you hear a confirmation tone from
the doorbell when registration completes. It takes about 0 seconds to complete
the registration process.
Deregister handsets and doorbells
If you want to replace a handset or doorbell, or reassign the designated handset
number of a registered handset, you must deregister all system devices and then
register each handset/doorbell individually.
Make sure you plug in AC power for the doorbells before deregistration.
To deregister all handsets and doorbells:
Press and hold / FIND HANDSET on the telephone base for about 0 seconds
until the IN USE light flashes.
Immediately press /FIND HANDSET again. You must press /FIND HANDSET
while the IN USE light is still flashing. The IN USE light flashes for about
five seconds.
All handsets show
Put handset on BASE to register and all doorbell lights
flash quickly. The deregistration process takes about 10 seconds to complete.
.
.
.
.
.
.
3.