Warrior 843 SAFARI REAR LIGHT BAR (1987 – 1996 Jeep YJ Wrangler) - Manual

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
[email protected]
SAFARI REAR LIGHT BAR
INSTALLATION INSTRUCTIONS
WAR 843
'87 - '96 Wrangler & ’97 & Up TJ
Read all instructions before proceeding.
Due to welding, handling, shipping, etc., the Light Bar legs may need to be
“adjusted” slightly (bent in or out) to fit correctly. A small amount of twisting will not hurt
the bar. Be careful not to scratch the paint as you install the legs.
1. Assemble the Light Bar by inserting lower mounting brackets onto the Light Bar
hoop and inserting snapper pins to hold in place. For a more permanent install
we recommend the use of the included _” x 1 _” bolts, washers, and Nyloc nuts.
The light tabs should be facing rearward.
2. Position the light bar assembly so that both mounting brackets are even with the
top of the body tub and the rear edge of the rear bracket is approximately 3/4"
rearward from vertical body seam. The two pairs of horizontal and vertical holes
should straddle the vertical seam, and the vertical holes should straddle the
horizontal seam. Make sure the rear reinforcing plates fit next to the inside body
seams. Mark where the holes are to be drilled and then remove the rear hoop.
3. Drill 3/8" holes where marked. Reinstall the rear Light Bar assembly. Install
provided bolts through the body tub using the reinforcing plates on inside of the
tub, and tighten loosely. Use of the bottom bolt on the rear mounting brackets is
optional to provide extra rigidity and does require installation of the backing plate
and nut from beneath the vehicle.
4. Lights should be installed per the manufacturer’s instructions.
If you need further assistance installing your product, please contact us by email at
[email protected] or call us at (888) 220-6861.
THANK YOU FOR PURCHASING WARRIOR PRODUCTS