Warrior 1505 – 87-96 YJ WRANGLER MIRROR RELOCATION BRACKET (1987 – 1996 Jeep YJ Wrangler) User Manual
Mirror relocation bracket, Installation instructions
Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
MIRROR RELOCATION BRACKET
INSTALLATION INSTRUCTIONS
Models:
WAR 1500 – 97-02 TJ WRANGLER
WAR 1501 – 07-11 JK WRANGLER
WAR 1505 – 87-96 YJ WRANGLER
Congratulations on your purchase of Warrior Products Windshield Mirror Relocation Bracket for your
Jeep. Be sure to open the box and examine the contents before beginning. Read these instructions
completely before starting your installation.
1. The Warrior Mirror Relocation Bracket attaches to the front of your windshield, on the lower part of the
windshield hinge.
2. Remove the large bolts on the windshield hinge. Remove one bolt at a time, CAREFULLY, to avoid
dropping backing nuts located inside the framework.
3. Mount the Warrior Mirror Relocation Bracket using the two (2) stainless steel bolts provided for each side.
4. When finished, be sure to go back and check the tightness of all bolts.
5. Install mirrors into relocation brackets. On YJ and TJ, the nut on the bottom of the mirror holds the mirror
into the bracket and is simply unbolted and swapped back and forth easily.
6. On the JK model, this is a torx head bolt instead of a nut. To remove the mirror from the factory mount on
the JK you will need to loosen the bolt until it is only slightly threaded and the head of the bolt is protruding
below the factory mirror mount.
7. The JK mirror is wedged into place with a taper, much like a steering tie rod end. Do not attempt to lift the
mirror out of the mount by hand, you will break the mirror. To free it from the taper tap on the head of the
bolt with a mallet upward until the mirror pops free. Remove the bolt and lift the mirror out of the mount.
* Note: Mirror relocation brackets are designed to be used when running no doors. Part #1501 is not
compatible with the factory full doors or half doors with the upper half in place. You will not be able to
open the door with these installed.
For more accessories for your Jeep visit us online at
www.warriorproducts.com
If you need further
assistance installing your product, please contact us by email at
or
call us at (888) 220-6861.
THANK YOU FOR PURCHASING WARRIOR PRODUCTS