Warrior 800022 REAR U-BOLT KIT (1987 – 1996 Jeep YJ Wrangler) User Manual
Warrior For the car
Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
800022
REAR U-BOLT KIT – JEEP YJ
INSTALLATION INSTRUCTIONS
Please read instructions before beginning installation. Check the kit hardware against the parts list. Be sure
you have all needed parts and know where they go.
1. Raise the rear of the vehicle and support with safety stands. Make sure the vehicle cannot roll.
2. Remove the rear wheels and tires. Remove stock shocks.
3. Support the rear axle housing with a floor jack (you must have stands under frame supporting vehicle
weight).
4. Loosen the four rear spring to axle U-bolts. (The remainder of the spring removal and installation is
performed one side at a time.)
5. On the driver side position a floor jack beneath the axle tube, just inside of the leaf spring. Raise the jack
until the axle just separates from the spring. Now remove the rear spring U-bolts. Repeat on the other
side.
6. Install new rear spring U-bolts lowering the jack supporting the axle to tighten. Torque bolts to 65 ft/lbs.
PARTS LIST
_” X 6 _” X 2 _” U-Bolts
_” Tall Lock Nuts (8)
700008 (4)
_” Flat Washers (8)