Warrior 44399PA Aluminum Dash (1987 – 1996 Jeep YJ Wrangler) - Manual

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone: (888) 220-6861
Fax: (503) 692-0364
[email protected]
www.warriorproducts.com
Aluminum Dash
Installation Instructions
For YJ-WRANGLER, 1987 thru 1995
Part Number – 44399/90424
Part Number – B4399
Part Number – 44399PA
Important:
Carefully follow instructions for safe and proper usage of this product. The manufacturer
and distributor of this product are in no way responsible for the customer’s failure to
adhere to the warnings and directions of these instructions, in the event of damage to the
consumer’s Jeep, or other properties and/or personal injury.
Tools Needed:
Phillips head screw driver
Box Contains:
1-Dash and 12” of two-sided tape.
There is a total of 10 Phillips head screws holding the stock dash in place. Remove the 10 screws
and hold your first piece, (which ever piece you choose, there is a total of three pieces) up against
the stock dash to make sure it fits properly. If you decide to use the tape, make sure you clean the
dash with some kind of cleaning solution so the two sided tape will stick on the dash. Put the
double sided tape at the lower part of the dash. It should fit nice and snug and may not need the
tape. Now reinstall the factory screws.