Warrior 879 SAFARI SPORT RACK (2007 – 2013 Jeep JK Wrangler) User Manual
Page 3
Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
3. Reversing the steps to assemble the rear hoop, remove the rear hoop. Do not remove the rear legs.
4. Lower the cargo basket off of the vehicle.
5. Reversing the steps to assemble the front hoop, remove the front hoop. Do not remove the front
mounting brackets.
6. Drill your 6 marked spots through both sides of the hoops. It is recommended that you start by drilling a
small 1/8” pilot hole first, followed by the 3/8” hole.
7. Use a can of flat black spray paint to cover the holes you drilled. This will help deter rusting. Allow time
to dry.
8. Reversing earlier steps in the instructions, re-assemble the front hoop, lift the cargo rack onto the vehicle,
and assemble the rear hoop.
9. Re-align your drilled holes to your mounting tabs, and use the remaining hardware to bolt the rack to the
hoops. Do not over tighten as you will crush the hoops.
Phase 4: Rack Quick Removal
1. Due to the large size of these racks, it may be difficult to install and remove alone. This is even more of
an issue with the larger 4-Door Wrangler and is best accomplished with a helper at each corner of the
rack.
2. Remove the 4 snapper pins or _” hardware at each corner of the rack.
3. Loosen the 4 Allen-head bolts on the front mount brackets a few turns.
4. Slowly and carefully lift the rack from its mounts and walk the rack backwards off of the Jeep.
Hard Top Removal Notes
1. Although recommended, it is not necessary to completely remove the rack to remove the hard top. The
Freedom panels will lift out normally without much interference from the rack.
2. Pull the rear 2 snapper pins or _” hardware from the legs and lift the rear hoop free. Rest the rear hoop
slightly offset from the rear legs so they do not slide down into place. This will give you enough
clearance to slide the hard top out toward the back of the Jeep.
Soft Top Removal Notes
1. In order to fold the soft top you will need to follow phase 4 to completely remove the rack.
2. It is possible to access the side and rear window panels without removing the rack.
3. You do have the option of removing the soft top without removing the rack. Unlatch the soft top at the
header bar and from the sides. Once those points are free and loose, you can remove the 4 bolts holding
the soft top to the roll bar and slide the top out the rear of the vehicle.
4. Once removed from vehicle, fold soft top normally and store in a secure place.
If you need further assistance installing your product, please contact us by email at
or call us at (888) 220-6861.
THANK YOU FOR PURCHASING WARRIOR PRODUCTS