Warrior 800001 FRONT COIL SPRING KIT (1997 – 2006 Jeep TJ Wrangler) - Manual

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone: (888) 220-6861
Fax: (503) 692-0364
[email protected]
www.warriorproducts.com
#800001
FRONT COIL SPRING KIT –JEEP TJ 4” LIFT
INSTALLATION INSTRUCTIONS
Please read instructions before beginning installation. Check the kit hardware against the parts list. Be sure
you have all needed parts and know where they go.
1. Raise and support the vehicle with jack stands.
2. Remove the tires and wheels.
3. Place reference marks (see left illustration below) on front driveshaft and axle. Disconnect the front
drive shaft and axle.
4. NOTE: If vehicle is equipped with ABS brakes, remove the sensor wire from the inboard side of the
lower control arm.
5. Locate the adjustment cam bolt, positioned on the front of the existing lower control arms, and make
index mark (as shown in the right illustration below).
6. Remove the lower control arms.
7. Remove the front shock absorbers. Disconnect the stabilizer link at the axle.
8. Lower the rear axle until the coil springs are free from the upper seat and remove the coil springs.
MAINTENANCE INFORMATION
It is the ultimate buyers responsibility to have all bolts/nuts checked for tightness after the first 100 miles. After that, check them
every 1000 miles. Wheel alignment steering system, suspension and drive line systems must be inspected by a qualified
professional mechanic at least every 3000 miles.
PARTS LIST
FRONT COIL SPRINGS
700015 (2)