Warrior 2205 – Locking Security Trunk (2007 – 2013 Jeep JK Wrangler) - Manual (Page 2)

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone: (888) 220-6861
Fax: (503) 692-0364
[email protected]
www.warriorproducts.com
6. You can now use your jigsaw to cut out your rectangle. Once cut it should look like this.
7. At this time, you may want to primer paint around the edges you’ve cut to prevent rusting. Allow to dry completely
before proceeding past this step
8. Locate the P shaped trim in your trunk kit. Cut four pieces 30_” long. Cut four more pieces 14” long.
9. Next, take only ONE of the 30_” pieces and trim the leg of the P off, so that it now is more of a D shape.
10. Place your D shaped trim along the edge of the hole you’ve cut in the floor along the rearmost edge of the vehicle.
These pieces stick with two-sided tape already adhered to the trim. Another long piece and two of the shorter pieces
you’ve cut will be used to lay trim around the entire edge of this open hole. You can either cut the leg of the P off of
these pieces as well, or you can just let the leg of the P hang freely into the opening. You will need to cut 45° angles
in the trim pieces so they fit together in a rectangle like a picture frame. Save the remaining trim pieces you’ve cut
for use later in this installation.
11. Lower your trunk box into the opening in your floor. The holes along the top lip are there to drill and pop rivet the
box into the floor. Drill these holes using a 13/64” drill bit.
12. Take a moment before riveting the box into place to trim your carpet to fit around the box. You should be able to
trim it so that it sits just under the box on the sides, making for a much better looking installation.
13. In your kit you will find shorter steel rivets and a few long steel rivets. The long steel rivets are intended to be used
along the edge of the box to the rearmost end of the vehicle, where the box is thick. The remaining short rivets will
fill the remaining holes in the sides and front of the box, and you should have 4 extras to attach the lid later in the
installation. Rivet the box into place now.
14. You should now have your hole cut, exposed metal primer painted, trim installed, and box riveted into place. You
can now proceed to installing the lid.