Warrior 91651 INTERIOR CARGO TRAY (1997 – 2006 Jeep TJ Wrangler) - Manual

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone: (888) 220-6861
Fax: (503) 692-0364
[email protected]
www.warriorproducts.com
91651
INTERIOR CARGO TRAY-(SOLID MOUNT)
INSTALLATION INSTRUCTIONS
1. Remove inner wheel well panels. This is the most difficult part of the installation, but is easier if
you destroy the plastic clips holding them on. We supply replacement clips to facilitate this.
2. Remove the rear seat. Remove both seat belts completely including roll bar tabs. Fold the carpet off
the wheel wells and set on the floor of the vehicle, or remove completely.
3. Assemble the complete tray outside of the vehicle. Legs point out.
4. Position the tray in the vehicle with the “single hole” legs to the rear of your Jeep. One small spacer
goes under each single hole leg to level the tray.
5. Install the tray in the vehicle in front of the roll bar. Keep as far to the rear as possible, and center left
to right.. Either drill through the support leg holes (4 each side), or mark the positions and drill with
the support legs and tray removed. Use a 7/16” drill bit.
6. With cargo tray and support legs removed from the vehicle, replace the carpet and locate the hole
positions through the carpet. Cut the holes into the carpet using a utility knife and clean the holes by
running the bolts back and forth through the openings. Reposition the tray and supports inside the
vehicle and install by bolting through the carpet holes and the wheel well. Use two flat washers for
each bolt.
7. Reinstall inner wheel panels using the plastic clips provided.
Enjoy your new Warrior Interior Cargo Tray!
Look for other great Warrior Products at “warriorproducts.com”.