Warrior 1418 TUBE DOOR MIRROR BRACKET (1955–1975 Jeep CJ5) - Manual

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
[email protected]
TUBE DOOR MIRROR BRACKET
INSTALLATION INSTRUCTIONS
WAR 1418
NOTE: These mirror brackets will fit any tube door with a 1_” outer tubing diameter. Mirrors are not
included in this kit. Any OEM or aftermarket mirror designed to fit an 87-02 Wrangler will work with
this kit.
Installation:
1. Locate a spot on your tube door where you would like to mount your mirror brackets
2. Use the 6mm bolts and nuts to clamp the bracket to the tube door.
3. Drop your mirror into the bracket and secure with the factory nut on the bottom.
4. Sitting in your driver seat with the tube door closed; set the mirror’s angle to the desired position
and lock it into place by tightening the mirror to the bracket securely. Do not over tighten as you
may damage the mirrors.
5. Finish the installation by hand adjusting the mirror lens to your preferred position.
Warrior also carries a full line of mesh covers, padding kits, and door limiting straps for your Tube
Doors. Go to
www.warriorproducts.com to view additional accessories available for your tube doors.
If you need further assistance installing your product, please contact us by email at
[email protected] or call us at (888) 220-6861.
THANK YOU FOR PURCHASING WARRIOR PRODUCTS