Warrior 593 REAR BUMPER (2007 – 2013 Jeep JK Wrangler) - Manual

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
[email protected]
JEEP WRANGLER JK REAR BUMPER
INSTALLATION INSTRUCTIONS
WAR 592/593
Installation:
1. Remove factory rear bumper - This is done by removing two 16mm bolts on either side of the
frame rail. The factory rear bumper will also have two braces bolted to the underside of the rear
cross member. Remove and discard these braces and hardware as they are no longer needed.
2. On factory hitch equipped vehicles, the bumper may need to be slightly modified to clear the
wiring plug bracket. Alternatively, the wiring plug bracket may be removed altogether.
3. Set bumper into place – Bolt into location with factory hardware. Ensure the bumper is aligned
and level, then tighten bolts.
4. Installation Complete - Your new bumper is now installed.
If you need further assistance installing your product, please contact us by email at
[email protected] or call us at (888) 220-6861.
THANK YOU FOR PURCHASING WARRIOR PRODUCTS