Warrior Generic Sway Bar Disconnect (Universal) User Manual
Page 2
Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
8. At this point you should have your mounts installed on both the sway bar and the axle mounts. Your next step is
to affix the bars onto the sway bar and onto the axle mounts by sliding them over the stud on the eyelets or top
stud mount. Align the hole in the stud to the hole in the round zinc bar and use the supplied pins to pin them into
place. Once you’ve attached both bars to each side of the sway bar, slide them onto the stud on the axle/bottom
mount and pin those into place as well.
9. Back track through your previous steps and tighten any bolts left loose during the installation. Ensure that the
wrap around retainers on your 4 lynch pins are secured into place.
10. Installation is complete. Now is a good time to do a double check on all of your bolts to ensure they are tight.
Warrior Products recommends that you occasionally re-check your bolts to be sure that they have not come
loose. If any bolts are consistently loosening themselves, loc-tite thread adhesive is recommended.