Warrior 90784 Adventure Door (1984 – 2001 Jeep XJ Cherokee) - Manual (Page 2)

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone: (888) 220-6861
Fax: (503) 692-0364
[email protected]
www.warriorproducts.com
Below: modified door hinge images for quick remove doors.
4. At this point you are finished. If you have made this modification to your hinges, you can now bolt
them to the doors, remembering to replace all of the shims in their original locations, and set them in
place to re-align them. If you chose to not modify your doors, you will need to reverse the
disassembly of the hinge to re-install them.
Section III - Tube Door Installation
1. Install the paddle handle into your new doors. The handles are attached using the 4 small screws
and nuts that are supplied in the kit. If you purchased mesh covers, these need to be installed before
the handle is installed.
2. Slide the door into place. Thread the securing nut onto the top pin of the door. Do not over
tighten.
Snubbers:
1. Included in your kit are two rubber snubbers and screws.
These are a universal part to help assist you in getting rid of
door rattle.
2. Locate a suitable location for the snubber to attach to the tube
door and mark for drilling.
3. Drill hole with a 1/8” drill bit
4. Use the #8 sheet metal screws included to pre-thread the hole.
You should be able to get it to cut threads with just a
screwdriver.
5. Use the same screws to secure the snubber to the door. Do
not tighten too much, or you’ll go right through the snubber.
Tighten until the screws head contacts the shoulder inside the snubber, then just snug down slightly more.
6. The image to your right shows a sample installation of the snubber.