Warrior 1480 - REAR LIGHT SPACER BRACKETS (2007 – 2013 Jeep JK Wrangler) - Manual

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
[email protected]
REAR LIGHT SPACER BRACKETS
INSTALLATION INSTRUCTIONS
WAR 1480 - ’07 & UP JK & UNLIMITED
Read these instructions completely before starting your installation.
1. Remove Spare Tire.
2. Unplug wire for tail light – you need to open tailgate and remove plastic vent on driver’s side.
3. Unbolt and remove Spare Tire Carrier.
4. Measure 3” up from the base for the light bracket and mark a line – Cut the Light Bracket on the
line using hacksaw or die grinder. (It will cut easy because it is alloy)
5. Take new bracket and lay it on top of the old bracket and mark the hole approximately _” from
the edge of both pieces and drill holes.
6. Cut wires and splice in 5inches of wire on each.
7. Remount Spare Tire Carrier, plug wire back in, pop vent cover back in place and mount Spare Tire.
If you need further assistance installing your product, please contact us by email at
[email protected] or call us at (888) 220-6861.
THANK YOU FOR PURCHASING WARRIOR PRODUCTS