Warrior 3850 FJ Cruiser Folding Pre-Runner Light Bar (2007-2013 FJ Cruiser) User Manual
Page 2
Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone: (888) 220-6861
Fax: (503) 692-0364
[email protected]
www.warriorproducts.com
11. Use the 3/8” washers and top lock nuts supplied to bolt the struts to the light bar and to the clam shell
brackets. The photo here is a good reference for steps 9 thru 11.
12. Slide a 3/8” USS (larger) flat washer and locking nut over the studs that mate the light bar to the mount
brackets and tighten.
13. At this point you should have everything assembled. Adjust your light bar angle and tighten clam shells to
secure it into place. Once wired you can adjust aim of the light bar more so to perfect the angle. You can
mark the clam shell location on the bar with tape or a marker for quick reference when folding and
unfolding so that you do not need to re-aim each time.
14. To fold the light bar down, loosen both clam shells and slide them backward as you guide the light bar
down. It does need to have some upward angle to it in order for it to properly lock into place. Once
folded back to a comfortable spot, tighten clamshells to lock into place.
15. Complete your installation by running your wiring. Warrior does not provide wiring instructions for your
light bar. You will need to choose a good location to get wires into the vehicle, most likely through a hole
you will create in the roof. To ease the wiring, Warrior recommends the use of the sPod power distribution
system. Visit
http://www.4x4s-pod.com/products/toyota/fj-cruiser
for more information.
For more information on Warrior Products Jeep Parts and Accessories, please visit us on the web
at
www.warriorproducts.com