Warrior 560 SERIES CHEROKEE BUMPER (1984 – 2001 Jeep XJ Cherokee) - Manual

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
[email protected]
CHEROKEE BUMPER
INSTALLATION INSTRUCTIONS
560 SERIES
Phase 1: Bumper Removal
1. Start by unbolting your bumper on each side. There are 3 bolts in a triangular pattern that hold the bumper in place.
Use a 15mm wrench or socket to remove them. If you have factory tow hooks, there will be an additional TORX
head bolt further back on the frame rail holding the brackets in place, as well as a bracket on the bottom side of the
frame rail.
2. The bumper should now be loose. On the passenger side, there should be a plastic vacuum canister bolted to the
bumper from the bottom. Remove the bolts and pull the bumper off of the Jeep. The canister can hang loose while
you install your bumper.
Phase 2: Bumper Installation
1. Slide your factory bumper, or new aftermarket bumper into place
2. Using the 3 bolts removed in Phase 1; attach the bumper to the vehicle. Thread all 6 bolts before tightening any of
them. Be sure to align the bumper so it is sitting straight on the vehicle as there is some play in the holes.
3. The last part of the installation is to re-attach your vacuum canister. You can either drill holes in the bumper to hold
it, or many people choose to relocate it into the engine bay.
Installation is completed. Visit www.warriorproducts.com to see more of our Jeep Cherokee Accessories.
If you need further assistance installing your product, please contact us by email at [email protected] or call
us at (888) 220-6861.
THANK YOU FOR PURCHASING WARRIOR PRODUCTS