Warrior 1115_RJR CG519B BREEZER TOP (1987 – 1996 Jeep YJ Wrangler) - Manual

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
[email protected]
BREEZER TOP
INSTALLATION INSTRUCTIONS
WAR 1115 / RJR CG519B
YJ ’92-’96
NOTE: Installation of this top requires a windshield retaining channel, if you do not have one it can be
purchased at your local offroad shop- Bestop part #51209-01 or OutLand part #90101.
1. Install retaining channel if needed
2. Place Breezer Top over windshield frame top side up
3. Fold the front edge over at a 180 degree angle & insert folded webbing strip into windshield channel
making sure it is fully in the channel all the way across
NOTE: It may help to use a rubber mallet to tap the strip into the channel – it is a tight fit
4. Flip the Breezer Top over & pull it towards the rear of the vehicle
5. Wrap & attach rear straps, cinch until you have proper tension on the Breezer Top from front to back
6. Long center strap goes to footman loop on windshield frame
7. Wrap and attach side straps same as rear, cinch until you have proper tension
8. Adjust all straps until you have a tight fit
Your Breezer Top is now fully installed.
Enjoy your new Breezer Top!
If you need further assistance installing your product, please contact us by email at
[email protected] or call us at (888) 220-6861.
THANK YOU FOR PURCHASING WARRIOR PRODUCTS