Warrior 91650 INTERIOR CARGO TRAY (1997 – 2006 Jeep TJ Wrangler) - Manual

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone: (888) 220-6861
Fax: (503) 692-0364
[email protected]
www.warriorproducts.com
91650
INTERIOR CARGO TRAY-(SLIDING VERSION)
INSTALLATION INSTRUCTIONS
1. Remove inner wheel well panels. This is the most difficult part of the installation, but is easier if
you destroy the plastic clips holding them on. We supply replacement clips to facilitate this.
2. Remove the rear seat or simple fold it forward. Remove the retractable seat belt holders from the
roll bar, rear inner roll cage bolts, and fold carpet off the wheel wells and set on the floor of the vehicle.
Modification or removal of the rear seat belt may be necessary on the 2003 version to properly install
the support legs.
3. Position the tray supports in the vehicle with the “single hole” legs to the rear of your Jeep. Line up
those holes with the existing roll cage “bolt holes”, and temporarily bolt in place.
4. Install the tray onto the supports (see note below), with tray in “locked” position, and determine the
hole positions for the front leg supports. Either drill through the support leg holes, or mark the
positions and drill with the support legs and tray removed. Use a 7/16” drill bit.
5. With cargo tray and support legs removed from the vehicle, replace the carpet and locate the hole
positions through the carpet. Cut the holes into the carpet using a utility knife and clean the holes by
running the bolts back and forth through the openings. Reposition the tray and supports inside the
vehicle and install by bolting through the carpet holes and the wheel well. Use two flat washers for
each bolt.
6. With the tray removed, fold the rear seat up between the tray supports and reinstall the factory seat
belts, taking care to position them around the leg supports and being careful not to impede the
movement of the tray. Reinstall the inner wheel wells using the plastic pushpins supplied. Note:
Always drive with lock pin in place for safety.
Enjoy your new Warrior Interior Cargo Tray!
Look for other great Warrior Products at “warriorproducts.com”.
Operating tips
Push the release tabs, where shown in the picture
to the right, to completely remove the sliding tray
from the mounts. When sliding the tray back into
the guides you will always encounter stiff resistance
as the bearings reseat themselves. Once installed
the tray will slide in and out easily.