Warrior 7311-7312-7313-7314 JK Tube Flares (2007 – 2013 Jeep JK Wrangler) User Manual
Page 2
Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone: (888) 220-6861
Fax: (503) 692-0364
[email protected]
www.warriorproducts.com
Rear Installation:
1. Begin by drilling out the holes for the expansion nuts. These nuts measure 5/8” (.625”). You will want to
drill these slightly smaller so they are tough to press into the holes. Using a step drill bit works very well
for being accurate when drilling the holes. The holes you see below are the ones you will want to drill.
Ignore the _” drill size on this photo, use the arrows for location reference only.
2. Install the supplied expansion nuts into these 5 holes on each side. Simply push the expansion nut into
the hole until the large shoulder is flush with the body metal.
3. In your kit you will find a length of rubber trim shaped like a “P”. Install this trim onto each flare mounting
plate using the adhesive backing already on the trim. When installing it, The very top of the “P” should be
sitting on the top edge of the flare mounting plate, or slightly above the top edge. You want to run this
trim along the entire length of the flares mount plate from end to end. You may need to make some small
relief cuts in the trim to get it to bend around the corners more easily.
4. When installing the driver side, you will notice that the flare overlaps the gas filler plastic trim ring slightly.
The flare will sit over this ring and the P-trim will cover any gap issues. If you would like, the filler trim ring
can be marked and trimmed for an even better fit. This is at your discretion and is not required to
complete installation.
5. Use three of your 2_” long bolts with a flat washer to bolt the flares onto the Jeep at the 3 front most
expansion nuts. Do not tighten bolts.
6. Use your 2” long bolts with flat washers to bolt the flares onto the Jeep at the 2 rear most expansion nuts.
Do not tighten bolts
7. Use the remaining two 2_” bolts with nuts and flat washers to bolt into the two open backed holes along
the top of the flare. Once all bolts are started, tighten all bolts.
8. You do not want to tighten the expansion nut locations too tight, they will end up pulling out of the holes.
Watch them closely as you tighten the flares.
9. This completes the installation.
Thanks for purchasing Warrior Products! Please see our other Jeep accessories at
www.warriorproducts.com
If you need further assistance installing your product, please contact us by email at
or call us at (888) 220-6861.