Warrior 800007 REAR TRAC ARM BRACKET (1997 – 2006 Jeep TJ Wrangler) - Manual

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
[email protected]
800007
REAR TRAC ARM BRACKET – ’97-‘02 JEEP TJ
INSTALLATION INSTRUCTIONS
Please read instructions before beginning installation. Check the kit hardware against the parts list. Be sure
you have all needed parts and know where they go.
1. Referring to the illustration shown below, install the rear trac arm bracket as shown using the hardware
provided.
2. Torque the existing track bar bracket bolt to 74 ft./lbs.
3. Drill out a 3/8” hole at the three 5/16” hole locations using the bracket as a template.
MAINTENANCE INFORMATION
It is the ultimate buyers responsibility to have all bolts/nuts checked for tightness after the first 100 miles. After that, check them
every 1000 miles. Wheel alignment steering system, suspension and drive line systems must be inspected by a qualified
professional mechanic at least every 3000 miles.
PARTS LIST
12MM X 50MM HEX BOLT (1) 12MM LOCKNUT (1)
12MM X 70MM HEX BOLT (1) TJ REAR TRAC ROD BRACKET (1)
70002