Warrior 2210 – Trunk w__o Lid (2007 – 2013 Jeep JK Wrangler) User Manual
Page 3
Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone: (888) 220-6861
Fax: (503) 692-0364
[email protected]
www.warriorproducts.com
14. In your kit you will find shorter steel rivets and a few long steel rivets. The long steel rivets are intended to be used
along the edge of the box to the rearmost end of the vehicle, where the box is thick. The remaining short rivets will
fill the remaining holes in the sides and front of the box, and you should have 4 extras to attach the lid later in the
installation. Rivet the box into place now.
15. The final portion of this installation will be to install the remaining trim over the top edge of the box, so that it
covers the rivets and seals to the lid when closed. You will need to cut 45° angles in it to once again make that
picture frame style rectangle. Below is an image of what your finished result should look like, lid excluded.
16. Complete this installation by buttoning up a few items. Re-install your subwoofer if your vehicle has one. Also, the
drain hole in your new security trunk accepts the drain hole in your factory storage compartment. Pull this rubber
plug out of the factory compartment and install it into the new trunk.
This completes the installation of your new Warrior Products JK Storage Trunk. If you want to see what else Warrior has to
offer, please visit us online at
www.warriorproducts.com
. If you need further assistance installing your product, please
contact us by email at
or call us at (888) 220-6861.
THANK YOU FOR PURCHASING WARRIOR PRODUCTS