VEGA VEGADIS 61 - Manual (Page 18)

6 Set up with the indicating and adjustment
module
6 .1 Short description
The indicating and adjustment module is used for measured value
display, adjustment and diagnosis. It can be mounted in the following
housing versions and instruments:
l All continuously measuring sensors in single as well as double
chamber housing (optionally in the electronics or connection
compartment)
l External indicating and adjustment unit
Note:
You can find detailed information on the adjustment in the operating
instructions manual "Indicating and adjustment module".
6 .2 Insert indicating and adjustment module
The indicating and adjustment module can be inserted into VEGADIS
61 and removed again at any time. It is not necessary to interrupt the
power supply.
For mounting proceed as follows:
1 Unscrew the housing cover
2 Place the indicating and adjustment module in the desired position
on the electronics (you can choose any one of four different
positions - each displaced by 90°)
3 Press the indicating and adjustment module onto the electronics
and turn it to the right until it snaps in.
4 Screw housing cover with inspection window tightly back on
Removal is carried out in reverse order.
The indicating and adjustment module is powered by the sensor, an
additional connection is not necessary.
Function/Configuration
Mount/Dismount indica-
ting and adjustment mo-
dule
18 VEGADIS 61
6 Set up with the indicating and adjustment module
27720
-EN
-120329