VEGA VEGADIS 175 - Manual (Page 9)

4 Mounting
4 .1 General instructions
Make sure that there are no vibrations in the mounting place.
Protect your instrument against heat, e.g. by other instruments
mounted too close
4 .2 Mounting preparations
Required tools:
l Screwdriver for recessed head screws size 2
4 .3 Mounting steps
Proceed as follows:
1 Prepare panel cut-out 45 + 0.6 x 92 + 0.8 mm according to
DIN
43700 in compliance with the illustration
92mm (3 5 /
8
")
45
m
m
(1
49
/ 64
")
92 mm (3 5 /
8
")
2 Insert the instrument with seal from the front into the cut opening
3 Press the fixing cramps into the respective gaps, hold the
instrument horizontally
4 Tighten the screws of the fixing clasps evenly with a screwdriver
Mounting location
Heat effect
VEGADIS 175 9
4 Mounting
24386
-
EN
-120531