Kaiser S4571 - Manual (Page 11)

11
EN
1
Connecting hot water
The inlet hose of the appliance can be also
connected to the hot water supply provided the
temperature doesn’t exceed 60° C.
In this case, both the wash cycle time and the
power consumption are reduced.
For hot water connection follow the same
procedure as that for cold water.
Connecting drain hose
 Connect the drain hose to the drain pipe 1
(diameter: 40 mm min.), or let it run directly
into the sink
2.
Use the special plastic hose support which is
delivered with the appliance.
The free end of the hose must be at a height of
400 to 1000 mm and must not be immersed. Make
sure that the hose is free from being bent or
flattened.
Disconnecting from water supply and
sewerage
To disconnect the Aqua-Stop inlet hose, cut off
water supply by turning off the faucet, screw out
the nut of the safety inlet hose which adjusts it to
the faucet.
Put the hose into the special storage compartment
at the back of the dishwasher.
In case the free end of the hose is put directly into
the sink, pay attention to the following:
If the sink is mounted at the height of 100 cm from
the floor, the excess water cannot be drained
directly into the sink.
To drain the excess water from the hose in this
case, you need a pail or any other suitable
container which should be put below the sink at
the side of it.
1
2