VEGA VEGACAP 66 - contactless electronic switch - Manual (Page 24)

24
7 Maintenance and fault rectification
VEGACAP 66 • - contactless electronic switch
30021-EN-130916
1 2 3
Fig. 29: Check the resistance in the probe
1 Shielding
2 Probe
3 Ground potential
Depending on the reason for the fault and the measures taken, the
steps described in chapter "Set up" may have to be carried out again.
7.3 Exchange of the electronics module
In general, all electronics modules of series CP60 can be inter-
changed. If you want to use an electronics module with a different
signal output, you can download the corresponding operating instruc-
tions manual from our homepage under Downloads.
Proceed as follows:
1. Switch off power supply
2. Unscrew the housing cover
3. Lift the opening levers of the terminals with a screwdriver
4. Pull the connection cables out of the terminals
5. Loosen the two screws with a screw driver (Torx size T10 or slot
4)
Reaction after fault recti-
fication